Emco F1-p Mill Mach3 convention, Spindle motor problem

**JAZZCNC** · 13-01-2016

You have no port number assigned to Spindle.

Can you show the drive because it may need to be enabled.

**andre13442** · 13-01-2016

the settings in the photos are of the one from whom I bought the machine. I myself had already both "Step Port" and "Dir Port 'changed from 0 to 1. So" step Port "is one and" Dir Port "is 1 but the result remained the same, no rotating spindle motor . I also have afther the change this, Mach3 restarts.
but thanks for your respons.....

**JAZZCNC** · 14-01-2016

So what about the enable pin on the drive.?

Unlike Steppers drives Servo drives need to be enabled. You say it's not connected. If not then this will most likely be why it's not working.

**andre13442** · 14-01-2016

the settings in the photos are of the one from whom I bought the machine. I myself had already both "Step Port" and "Dir Port 'changed from 0 to 1. So" step Port "is one and" Dir Port "is 1 but the result remained the same, no rotating spindle motor . I also have afther the change this, Mach3 restarts.
but thanks for your respons.....