Aligning Gantry

[JAZZCNC]

Thanks Jazz. I was going to use a switch but wanted to tune the alignment from that trigger point.

Well in that case then I think the ESS Plug-in may have this feature.? I know the early Plug-ins didn't have it but I did hear something mentioned about maybe be added to plug-in. That saidKnowing how bad Warp9 are at software updates then I wouldn't hold my breath.!!

[Tenson]

Hi Jazz,

I had a look yesterday. There is a homing dialogue for ESS but when enabled it makes both axis work and home individually which wasn't much help.

Simon

Well in that case then I think the ESS Plug-in may have this feature.? I know the early Plug-ins didn't have it but I did hear something mentioned about maybe be added to plug-in. That saidKnowing how bad Warp9 are at software updates then I wouldn't hold my breath.!!

[JAZZCNC]

Hi Jazz,

I had a look yesterday. There is a homing dialogue for ESS but when enabled it makes both axis work and home individually which wasn't much help.

Simon

Does it have an Offset option.?

Also what you mean Homing individually wasn't much help.? You need or want it to Home each axis individually so can square gantry. Do you mean it tried to move just one axis.?
If so then it's just a setting in Mach3.!