Cnc plasma build need help plz

[Lewywri89]

I needed 1 more driver to slave the y axis anyway so next payday its off to zappautomation for 3 em503's coz they ran the motors very smooth
I will start my control box from scratch with 2 48v psu that can be adjusted down to 43-45v (is this okay)??
And also I hope to upgrade to a ethernet controller instead of the bob but not sure what or where to get 1 from but im sure you can point me in the right direction
Absolutely gutted about the broken drives but I suppose ill never do it again a haha


Sent from my D6503 using Tapatalk

[Clive S]

I needed 1 more driver to slave the y axis anyway so next payday its off to zappautomation for 3 em503's coz they ran the motors very smooth
I will start my control box from scratch with 2 48v psu that can be adjusted down to 43-45v (is this okay)??
And also I hope to upgrade to a ethernet controller instead of the bob but not sure what or where to get 1 from but im sure you can point me in the right direction
Absolutely gutted about the broken drives but I suppose ill never do it again a haha


Sent from my D6503 using Tapatalk

What make you think you have blown the drives? post a pic of the faulty drive and say how you think you have blown it. Also why will you need two power supplies?