Threaded View
-
21-01-2016 #18
Last Activity: 7 Hours Ago
Good drivers are essential as they also take account of resonance, current control etc If you buy decent drive they can of course be used again if you decide on a bigger machine
Originally Posted by brumster
Understood, thanks
Contemplating whether to make my own drivers and motion controller, but sounds like the latter is out! Too much coding effort anyway, I see there's an open source one out there and the code alone took 4 years of development... so no, I won't be going that route :)Last edited by Clive S; 21-01-2016 at 06:19 PM.
..Clive
The more you know, The better you know, How little you know
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
"Hacking" and "Modding"
By magicniner in forum General DiscussionReplies: 15Last Post: 07-01-2015, 08:59 PM -
CNC machine "Spanish" model . Advice and opinions needed!
By shapebusters in forum Machine DiscussionReplies: 17Last Post: 12-03-2014, 06:21 AM -
Interesting Article "Makers unite - the revolution will be home-made"
By Fivetide in forum General DiscussionReplies: 4Last Post: 28-09-2012, 12:06 PM -
"Racks" VS "ball screw"
By C.AlveSilva in forum Linear & Rotary MotionReplies: 1Last Post: 17-04-2012, 11:53 PM -
My apologies to "Andy" for the delay ... internet connection problem
By ali hedi in forum General DiscussionReplies: 1Last Post: 25-12-2010, 06:05 PM
Bookmarks