Need Help! Gerber System 48 Build Issues Video and Pictures Inside!

[JAZZCNC]

You could have two issues working together here.?

First one is that your in Exact stop mode. This is easy to tell by looking at the top bar to see if G61 also on lower right if CV button is Off (not lit blue)

The other is the fact your G-code is using little lines to go around corners rather than creating arc's.

Together the will give you this stuttering because Exact stop will do just that and stop for fraction sec at end of each little line.

Try this again but first go to MDI and type G64 to make sure in Constant Velocity mode.

To fix the G-code then you need Post that use Arc's. I think Aspire has post that say's mm/arc's.