Need Help! Gerber System 48 Build Issues Video and Pictures Inside!

[toby]

I've had a hectic few months with work but I've finally got a break in my schedule to dedicate the next 2 weeks to getting this machine up and running. I managed to take out the previous configuration of the x axis stepper motor and now instead of the the x axis stepper motor being on top of the gantry its fixed securely inside now with the full four bolts. On doing so I noticed one of the cogs had damaged teeth and had to get a new one made.

Last night I had a couple hours free so I thought foolishly that I could get the VFD setup with mach 3 in this time. Anyway I followed the manual here http://www.omc-stepperonline.com/dow...ers_Manual.pdf but I wasnt entirely sure with the setup coming out of the VFD ASKPOWER A131 as all I could find were these instructions http://www.instructables.com/id/6-Ax...reak/?ALLSTEPS

The spindles runs from the panel fine. All and any help is appreciated thank you in advance