Need Help! Gerber System 48 Build Issues Video and Pictures Inside!

[JAZZCNC]

You could have two issues working together here.?

First one is that your in Exact stop mode. This is easy to tell by looking at the top bar to see if G61 also on lower right if CV button is Off (not lit blue)

The other is the fact your G-code is using little lines to go around corners rather than creating arc's.

Together the will give you this stuttering because Exact stop will do just that and stop for fraction sec at end of each little line.

Try this again but first go to MDI and type G64 to make sure in Constant Velocity mode.

To fix the G-code then you need Post that use Arc's. I think Aspire has post that say's mm/arc's.

[toby]

Hi Jazz thank you for the fast response, I input the g64 and checked aspire and I saved the toolpath selecting 'mach2/3 arcs (mm)'. I still got the stuttering movement issue? I've uploaded the setting pages below if that gives a better insight to the issue.

[toby]

I converted the design to lines and arcs before importing into aspire, did this make a difference to the lines going round the corners? I can already tell that the file size is different, The new code is uploaded below.
thanks for the help
Toby