Denford TRIAC Servo VMC 1PH

**Chaz** · 31-01-2016

Nice machine, virtually identical to mine but with slightly different electronics and placement for some items.

Out of interest (ive changed my motors since and modified to Mach 3 via CS Labs), what is the highest feedrates you can get (X and Y) in mm/min, would you know or be able to check please?

Free bump for a nice machine.

Thanks

**andy_con** · 31-01-2016

Awesome machine, I have a non servo triac

Little on the upper side price wise as it's not been converted

**fidia** · 31-01-2016

Originally Posted by Chaz

Nice machine, virtually identical to mine but with slightly different electronics and placement for some items.

Out of interest (ive changed my motors since and modified to Mach 3 via CS Labs), what is the highest feedrates you can get (X and Y) in mm/min, would you know or be able to check please?

Free bump for a nice machine.

Thanks

Hi I believe the set feedrates are 1.6m/min however I would expect the machine can do 2 to 2.5m/min

thanks

**Chaz** · 31-01-2016

Originally Posted by fidia

Hi I believe the set feedrates are 1.6m/min however I would expect the machine can do 2 to 2.5m/min

thanks

Thanks. Mine is running 2000mm/min at the moment. The original servos are higher speed (mine are 8K) whereas my current servos are 3K, so Im OK with this as a speed if it does it consistently and accurately.

**fidia** · 31-01-2016

My current stepper triacs are running 2.25m/min in X and Y and 1.5m/min in Z.

With an 80V driver they probably could go a bit faster. I was intent on converting the servo triac however am moving due to work.

If you are interested in the machine I would probably sell at a lower price.

**Chaz** · 31-01-2016

Originally Posted by fidia

My current stepper triacs are running 2.25m/min in X and Y and 1.5m/min in Z.

With an 80V driver they probably could go a bit faster. I was intent on converting the servo triac however am moving due to work.

If you are interested in the machine I would probably sell at a lower price.

Thanks. Ive got one but I agree, over £3K pre modernising is a bit pricy.

**andy_con** · 31-01-2016

Id love the machine but already own two denford mills

**Tommy** · 10-01-2017

Originally Posted by Chaz

Nice machine, virtually identical to mine but with slightly different electronics and placement for some items.

Out of interest (ive changed my motors since and modified to Mach 3 via CS Labs), what is the highest feedrates you can get (X and Y) in mm/min, would you know or be able to check please?

Free bump for a nice machine.

Thanks

Hi, Do you have “baldor D281 motion control card for a triac P. C. (denford), red 7-segment LED display type. The firmware is ESMINT 3.28 V1.6H/S - JD5.”

**andy_con** · 10-01-2017

Originally Posted by Tommy

Hi, Do you have “baldor D281 motion control card for a triac P. C. (denford), red 7-segment LED display type. The firmware is ESMINT 3.28 V1.6H/S - JD5.”

Are you sure you have asked on the forum enough times?

**Chaz** · 10-01-2017

Originally Posted by andy_con

Are you sure you have asked on the forum enough times?

I think he has posted in every Triac there there is. My email went mad with all the updates.

Ill need to go through the stuff I have to check. Picture of the card will help me see if I have one.