New milling motor Proxxon FBS 240/E upgrade to Kress 1050 FME-1

**Boyan Silyavski** · 04-02-2016

The Chinese water spindle is way better than the Kress, which is not really made for that job. Its like comparing Ferrari to a tractor

**Zynch175** · 04-02-2016

Originally Posted by Boyan Silyavski

The Chinese water spindle is way better than the Kress, which is not really made for that job. Its like comparing Ferrari to a tractor

I was leaning towards the Chinese spindle, since i saw a comparison, and it is a lot quieter.
As far as I know Ferrari also made tractors, and the Proxxon I had was not made for the job, but it worked for the last few years. But as I said, I will most likely go with a Chinese spindle.

Poslano z mojega ONE A2003 z uporabo Tapatalk

**JAZZCNC** · 04-02-2016

Originally Posted by Zynch175

As far as I know Ferrari also made tractors, and the Proxxon I had was not made for the job, but it worked for the last few years.

Think you'll find that was Lamborghini.!!. . . But Boyan is correct Kress are toys in comparison.

**Zynch175** · 04-02-2016

So I found some local guys doing a group buy, and I got in, so I ordered a 1,5kW spindle, since the 2,2kW are quite a bit over my budget.

**Chaz** · 05-02-2016

I had a Kress. Noisy as hell. Go for a smaller Chinese Watercooled spindle if you can.

**Neale** · 05-02-2016

And I wouldn't worry about going for the smaller spindle. I doubt that many home-built machines can fully load the bigger spindle and the main reason for choosing the larger size is they usually take ER20 collets which allow up to 1/2" cutter shanks.

**Chaz** · 05-02-2016

Indeed. The Kress is only rated at 1050 Watts. I think it will smoke before it delivers that type of output.

**Zynch175** · 05-02-2016

Originally Posted by Neale

And I wouldn't worry about going for the smaller spindle. I doubt that many home-built machines can fully load the bigger spindle and the main reason for choosing the larger size is they usually take ER20 collets which allow up to 1/2" cutter shanks.

I went for the 1.5kW one, since the group buy has the 1.5kW or 2.2kW. And I decided that the new spindle is going on the new machine, that is in the process of designing (about 1000x1500 in size). It is going to be a modified frame of an embroidery machine, and the stepper motors and their drivers will also come from the machine. Once I get some drawings together I will post it to get an opinion on the design.

Poslano z mojega ONE A2003 z uporabo Tapatalk

**Davek0974** · 19-02-2016

Originally Posted by Neale

And I wouldn't worry about going for the smaller spindle. I doubt that many home-built machines can fully load the bigger spindle and the main reason for choosing the larger size is they usually take ER20 collets which allow up to 1/2" cutter shanks.

I've got a 2.2kw WC spindle coming for a new build, what size cutter could these handle in aluminium??

I have read that torque drops badly at lower speeds but what is the usable range???