got 2 outputs from controller, need to connect 3 leds to them, any solution?

[JAZZCNC]

Thank you jazz, initially I thought of something similar with no outputs dedicated for this, like the HWenable from CSMIO also powers the green led while the E-Stop when goes low red light comes up using relay or something. but then I found a link in CSMIO website which someone put up to show an example of using the outputs to show the states as they are in mach3 instead so I thought of doing it like that, but your way I guess is a good compromise! screw the yellow light lol ( it will be the NC one) and red and green will come from mach3 based on the light state there.

For reference: http://www.cs-lab.eu/en/artykul-131-...nal_Tower.html

So what do you want the light to tell you.? E-stop and system Reset or green if program Cylcle is running.?

If just system Reset then don't bother with using any outputs just use Contacts on Master relay.!

Regards the Cslabs Tower then I use similair setup using outputs and Macro pump to control the LED status on the Front panels fitted to machines I build.
Led's controlled are E-stop, Cycle running, Feedhold, Step or Continous mode (with flashing Led). These are the kind of things you can easily do with plenty of I/O.