Thread: V-Groove Bit Recommendation?
Threaded View
-
04-02-2016 #3
Last Activity: 16-02-2019
Been using a cheap 90 Degree V-Groove with a 22mm cutting edge from ebay. Cost about £ 4. Cut lots of MDF & softwood with it absolutely fine.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Recommendation of Woodwork Shop to Hire?
By Tenson in forum General DiscussionReplies: 6Last Post: 31-08-2015, 02:27 AM -
Recommendation for getting MDF worked on in North London?
By surv1v0r in forum General DiscussionReplies: 0Last Post: 10-09-2014, 12:09 AM -
where do you get the v groove channel extrusions from
By nobby in forum Marketplace DiscussionReplies: 1Last Post: 29-04-2014, 04:19 PM -
Spindle Motor Recommendation.
By cambesol in forum Marketplace DiscussionReplies: 0Last Post: 21-11-2013, 12:15 PM -
Router recommendation for University
By S2L in forum Marketplace DiscussionReplies: 12Last Post: 05-12-2012, 11:58 AM
Bookmarks