Comparing motion controllers...

[komatias]

To answer your last point,

When you set up your stepper drives system, you should set the drivers to microstep. That will make them run smoother and also allow you to have better resolution of angle. 10-16 microsteps is good depending on what resolutions you really want.

[JW1977]

When i looked at stepper motors i found motors with different step angles.
0.9° - 400 steps/revolution
1,8° - 200 steps/revolution

Im thinking that if i choose the one with the higher resolution Everything will be better...?
Allthough ive got a feeling its not that simple...