To big steppers?

[Clive S]

You and others say that the "hard correction procedure" work well so im leaning towards that or the belt drive...

I would go with the single belt rather than the solid stops It is a tried and tested route with many people using it. If you can afford it go with the mains 230V drive and the nema 34 for the twin screws. The AM882 drives are good they also have stall detection. Make sure you get the 8 wire low inductance motors for the Y and Z axis

Good luck with the build

[JW1977]

I would go with the single belt rather than the solid stops It is a tried and tested route with many people using it. If you can afford it go with the mains 230V drive and the nema 34 for the twin screws. The AM882 drives are good they also have stall detection. Make sure you get the 8 wire low inductance motors for the Y and Z axis

Good luck with the build

Im gonna do do that!
I havent studied the drivers that much yet but i mentioned the AM882 as an example of a "better" driver.
I will definetly go for Mains 230V.

Thanks!