-
17-02-2016 #1
hi chaps. I am running mach 3 to a mf70 mill. the mach 3 is showing the tool runs etc, and the x,y,z lines all show movement on the screen. but there is no movement at the mill. it was working yesterday, but I have been playing around with buttons to fix the first fault, which was the program jamming on tool change. the machine control card is the TB6560-based stepper. can anyone point out what I need to do, I don't think it is the hardware at fault, just the settings. is there a way to check these out, or is their a correct group of settings for the machine. thanks. michael
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Plasma cutting fault diagnoses....
By Davek0974 in forum Plasma Table MachinesReplies: 15Last Post: 01-04-2014, 07:04 PM -
heidenhain vrz731b fault
By p.cage in forum General ElectronicsReplies: 0Last Post: 31-01-2014, 03:56 PM -
Servo fault handling
By m_c in forum Motor Drivers & ControllersReplies: 0Last Post: 23-09-2013, 04:39 PM -
Heidenhain DRO fault
By Lancer in forum General ElectronicsReplies: 5Last Post: 29-06-2012, 09:57 AM -
ATX cycling fault?
By mocha in forum Power SuppliesReplies: 7Last Post: 07-12-2011, 02:08 PM
Bookmarks