What have I done!

[artmin]

I did have a rummage for another to test it, but I'll have to dig deeper.

[artmin]

Unfortunately it's not the cable. I just managed to fit the ribbon on the control board straight into the back of the parallel port and it's still doing the same.

Is there anybody in the UK who takes this kind of repair job on or is it better to ditch it and build a new controller with bits from Zapp? I was just very happy with how stable the system was. I could throw half a million lines of code at it and it would take it in it's stride.

[BernieNUFC]

I could give you the details of a company we have used for 20 years that do repairs down to component level and hvae made boards etc for us, not sure on how it stands of advertising tho as i cant pm you

malc

[ptjw7uk]

Sounds as if somethings not connected right with the power supply, check with a volt meter and then check again!

Peter