New Build, Aluminium Frame Router/Mill

[JAZZCNC]

One thing for certain though is that it's as rigid as a rigid thing at a rigid party and it weighs a ton! All of which are good properties i think ;)

So Black Adder you saying one my Baby's is Simple Fat Lass who's Harder than Hard thing in Hard place.!. . . . I'll be sending Hot poker your way.

Anyway who said was your friend

[Davek0974]

Ok I presumed friendship ;)

Certainly tough-nut though ;)

[JAZZCNC]

Ok I presumed friendship ;)

Know what they say about Assuming.??? . . . .Thou ya got it right this time..

Certainly tough-nut though ;)

Should Expect nothing less from Yorkshire Lass.!. .

[Davek0974]

Know what they say about Assuming.??? . . . .Thou ya got it right this time..



Should Expect nothing less from Yorkshire Lass.!. .

I hear the tea is pretty good stuff too ;)

[Davek0974]

One almost oversight i spotted tonight - the holes on the ballscrew nut flanges, i presume these are for grease nipples?

To get to my Z axis ones will mean taking the bed off - no big deal there but the z axis one is buried.

The question - how often do screws need greasing?

[Davek0974]

Got the Y axis screws synchronised and belt fitted tonight, fine-tuned the ballscrew nut brackets and the bottom end is just about done, threw the bed and over-bed on for a photo...



The 15mm alu over-bed will drilled/tapped for mounting studs etc, it's a little shorter than i would like and cost me about 50mm of Y travel but it will do ok for a while.

Just waiting for some alu bar to arrive for the X axis motor mount and we will be wiring up for motion testing :)

[sinnsvak]

I think for the size, it will perform very well!