New Build, Aluminium Frame Router/Mill

[Davek0974]

Things are progressing...



Leaving it on the little bench i made to build it, fits well and the electrics will fit underneath nicely.

Since the picture was taken I have fully wired the panel and tested the safety circuit etc, this is now in the cabinet and waiting connection. The VFD is mounted behind the cabinet so i can see it from under the table, this keeps it safe from flying chips etc and away from the drive electronics.

I have the E-stop circuit controlling the VFD and cooling pump supplies, it also has a connection to the BOB to tell Mach3 that it's in E-Stop, this circuit also functions as a No-Volt-Release system to stop the spindle restarting after a power loss.

The pump supply and misting system solenoid is controlled from a relay board driven by the VFD internal relay so they come on and off as the VFD does, the misting supply also has a front panel switch so i can leave it off when cutting wood etc.

Tomorrow will be wiring, testing and making the bed and fitting it hopefully.