Thread: XHC Motion Card, MK3-III
Threaded View
-
26-11-2016 #7
Last Activity: 26-11-2016
I'm sorry I don't think I explained what I'm needing help with correctly. What I'm asking is what pin and port numbers do I set for the outputs 2-7 located on the mach3 motion card in the Mach3 three software. It's the MKX-IV USB motion board.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: 3 Axis CNC USB Motion Card Mach3 200KHz Breakout Board For Stepper/Servo Driver
By dudz in forum Items For SaleReplies: 0Last Post: 03-01-2015, 03:40 PM -
Parallel PCI Card Experience
By andy0202 in forum Computer HardwareReplies: 11Last Post: 24-08-2012, 10:39 PM -
PCI parallel card / BOB
By artmin in forum Computer HardwareReplies: 11Last Post: 30-01-2012, 04:38 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM -
Controller card selection
By Hogout in forum Motor Drivers & ControllersReplies: 7Last Post: 14-05-2009, 11:26 PM
Bookmarks