Thread: Engraving issues
Threaded View
-
27-02-2016 #1
Hey guys, I thought the machine was pretty good, setup wise, until I tried to do some small engraving (100x50mm) but turns out I have some issues!
Can anyone point me in the right direction with this as to what the issue could be?
All nuts and bolts are tight, no slop in any axis and slaved motors are spot on. I'm actually stumped
Sent from my iPhone using Tapatalk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
50w laser - PSU issues?
By calida in forum Laser Machines & BuildingReplies: 1Last Post: 09-02-2016, 04:25 PM -
Limit switch issues?!?
By jonbabbz in forum General ElectronicsReplies: 10Last Post: 06-02-2014, 07:37 PM -
Calibration issues, advice needed
By Kernow Jim in forum Motor Drivers & ControllersReplies: 16Last Post: 23-01-2014, 07:18 PM -
Page layout issues...
By irving2008 in forum General DiscussionReplies: 3Last Post: 09-08-2012, 08:10 PM -
Cable + Connector issues
By tom3d in forum General ElectronicsReplies: 0Last Post: 09-01-2012, 07:56 PM
Bookmarks