Thread: Engraving issues
Threaded View
-
27-02-2016 #15
Last Activity: 14-01-2024
Ok getting to the backlash, is this normal? Seems to bounce back then slowly zero, am I doing something wrong?
This is on the left side of the gantry, bot on the right side it's a different story.
http://youtu.be/GcV8a14q7xs
Sent from my iPhone using Tapatalk
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
50w laser - PSU issues?
By calida in forum Laser Machines & BuildingReplies: 1Last Post: 09-02-2016, 04:25 PM -
Limit switch issues?!?
By jonbabbz in forum General ElectronicsReplies: 10Last Post: 06-02-2014, 07:37 PM -
Calibration issues, advice needed
By Kernow Jim in forum Motor Drivers & ControllersReplies: 16Last Post: 23-01-2014, 07:18 PM -
Page layout issues...
By irving2008 in forum General DiscussionReplies: 3Last Post: 09-08-2012, 08:10 PM -
Cable + Connector issues
By tom3d in forum General ElectronicsReplies: 0Last Post: 09-01-2012, 07:56 PM
Bookmarks