. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 27-02-2016 #1
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Derek take another pic closer up to curve please.

    This looks like end float to me because the top of the E as kink in it just where direction change would occur.? Are the screws moving in the end bearings.? Give it firm shake.

    Edit: Could also be how you have SW setup because if the display settings are low it will break arcs into lines for resolution purposes. Not sure if when exporting to DXF it changes anything or just puts out whats on screen. How does it look on SW screen.?
    Last edited by JAZZCNC; 27-02-2016 at 12:13 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 50w laser - PSU issues?
    By calida in forum Laser Machines & Building
    Replies: 1
    Last Post: 09-02-2016, 04:25 PM
  2. Limit switch issues?!?
    By jonbabbz in forum General Electronics
    Replies: 10
    Last Post: 06-02-2014, 07:37 PM
  3. Calibration issues, advice needed
    By Kernow Jim in forum Motor Drivers & Controllers
    Replies: 16
    Last Post: 23-01-2014, 07:18 PM
  4. Page layout issues...
    By irving2008 in forum General Discussion
    Replies: 3
    Last Post: 09-08-2012, 08:10 PM
  5. Cable + Connector issues
    By tom3d in forum General Electronics
    Replies: 0
    Last Post: 09-01-2012, 07:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules