. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #11
    Defo Backlash or Slop.!! If you look every curve as got kink at 90deg segment were direction change occurs.

    Edit: Actually looking closer it's just before the 90deg segmant which is strange but still I think it's mechanical rather than G-code. Can you post the G-code file.

    Don't know how you had them on bed but you will be able to work out which axis is the problem.
    Last edited by JAZZCNC; 27-02-2016 at 12:43 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 50w laser - PSU issues?
    By calida in forum Laser Machines & Building
    Replies: 1
    Last Post: 09-02-2016, 04:25 PM
  2. Limit switch issues?!?
    By jonbabbz in forum General Electronics
    Replies: 10
    Last Post: 06-02-2014, 07:37 PM
  3. Calibration issues, advice needed
    By Kernow Jim in forum Motor Drivers & Controllers
    Replies: 16
    Last Post: 23-01-2014, 07:18 PM
  4. Page layout issues...
    By irving2008 in forum General Discussion
    Replies: 3
    Last Post: 09-08-2012, 08:10 PM
  5. Cable + Connector issues
    By tom3d in forum General Electronics
    Replies: 0
    Last Post: 09-01-2012, 07:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •