. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    I've just ran the machine again with a hand on each axis! Now, on the right side of the machine it seems to jump forward ever so slightly I'm guessing this is where the issue lays!!

    Backlash - maybe sorting the backlash for a legend like yourself it's easy but this will be the first try for me haha can you give the best way to do this?


    Sent from my iPhone using Tapatalk

  2. #2
    It all depends where the backlash is coming from, could be loose shaft-end block allowing the shaft to move end-end, slack nut and some other possibilities.

  3. #3
    Quote Originally Posted by D-man View Post
    Backlash - maybe sorting the backlash for a legend like yourself it's easy but this will be the first try for me haha can you give the best way to do this?
    Leg End more likely but what I'm certainly not is Mystic Meg. Can't tell you how to fix when don't know whats wrong.??

    I'll make a small wager that jumping is the Rotating nut needs adjusting.!
    Last edited by JAZZCNC; 27-02-2016 at 01:16 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 50w laser - PSU issues?
    By calida in forum Laser Machines & Building
    Replies: 1
    Last Post: 09-02-2016, 04:25 PM
  2. Limit switch issues?!?
    By jonbabbz in forum General Electronics
    Replies: 10
    Last Post: 06-02-2014, 07:37 PM
  3. Calibration issues, advice needed
    By Kernow Jim in forum Motor Drivers & Controllers
    Replies: 16
    Last Post: 23-01-2014, 07:18 PM
  4. Page layout issues...
    By irving2008 in forum General Discussion
    Replies: 3
    Last Post: 09-08-2012, 08:10 PM
  5. Cable + Connector issues
    By tom3d in forum General Electronics
    Replies: 0
    Last Post: 09-01-2012, 07:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •