Thread: Engraving issues
Threaded View
-
27-02-2016 #11
Cheers is it normal for the ball nuts to be magnetised!!?? I'm think it is due to them running up and down the screws all day. I'm sure I've just had a small jolt while checking ball nut screws! Trouble is I'm scared to check again maybe it was the dodgy tenant in my hand...
It's like plucking up the courage to stick your tongue on a 9v battery all over again hahaha
Sent from my iPhone using Tapatalk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
50w laser - PSU issues?
By calida in forum Laser Machines & BuildingReplies: 1Last Post: 09-02-2016, 04:25 PM -
Limit switch issues?!?
By jonbabbz in forum General ElectronicsReplies: 10Last Post: 06-02-2014, 07:37 PM -
Calibration issues, advice needed
By Kernow Jim in forum Motor Drivers & ControllersReplies: 16Last Post: 23-01-2014, 07:18 PM -
Page layout issues...
By irving2008 in forum General DiscussionReplies: 3Last Post: 09-08-2012, 08:10 PM -
Cable + Connector issues
By tom3d in forum General ElectronicsReplies: 0Last Post: 09-01-2012, 07:56 PM
Bookmarks