. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 27-02-2016 #14
    Davek0974's Avatar
    Lives in Bishops stortford, United Kingdom.
    Davek0974
    Last Activity: 20-12-2024 Has been a member for 9-10 years. Has a total post count of 1,165. Received thanks 78 times, giving thanks to others 226 times.
    Whatever you do, get a continuous earth from the body of the spindle (If metal) or the mount back to the star point as mentioned, without this, any stray voltage is going to earth via you ballscrews, nuts and bearings - this is seriously bad news and can ruin balls in short time, use multi-strand wire similar to heavy speaker cable etc - flexible but lots of strands.
    https://ddmetalproducts.co.uk
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Davek0974 For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. 50w laser - PSU issues?
    By calida in forum Laser Machines & Building
    Replies: 1
    Last Post: 09-02-2016, 04:25 PM
  2. Limit switch issues?!?
    By jonbabbz in forum General Electronics
    Replies: 10
    Last Post: 06-02-2014, 07:37 PM
  3. Calibration issues, advice needed
    By Kernow Jim in forum Motor Drivers & Controllers
    Replies: 16
    Last Post: 23-01-2014, 07:18 PM
  4. Page layout issues...
    By irving2008 in forum General Discussion
    Replies: 3
    Last Post: 09-08-2012, 08:10 PM
  5. Cable + Connector issues
    By tom3d in forum General Electronics
    Replies: 0
    Last Post: 09-01-2012, 07:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules