Thread: Engraving issues
Threaded View
-
27-02-2016 #19
Last Activity: 06-07-2022
That is lost motion somewhere, either backlash or the screws/bearings are not tight. The blips happen when start accelerating when you change direction as you can see. Also have you changed any setting for backlash compensation in the software?
https://emvioeng.com
Machine tools and 3D printing supplies. Expanding constantly.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
50w laser - PSU issues?
By calida in forum Laser Machines & BuildingReplies: 1Last Post: 09-02-2016, 04:25 PM -
Limit switch issues?!?
By jonbabbz in forum General ElectronicsReplies: 10Last Post: 06-02-2014, 07:37 PM -
Calibration issues, advice needed
By Kernow Jim in forum Motor Drivers & ControllersReplies: 16Last Post: 23-01-2014, 07:18 PM -
Page layout issues...
By irving2008 in forum General DiscussionReplies: 3Last Post: 09-08-2012, 08:10 PM -
Cable + Connector issues
By tom3d in forum General ElectronicsReplies: 0Last Post: 09-01-2012, 07:56 PM
Bookmarks