Thread: a little more help needed
-
29-02-2016 #1
hi, today I wired up a new tb6600hg. I have set the pins etc as per the instructions. but this is what I am now getting. when power on all motors lock up. put the x and y axis are at the end of their lead screws and the motor only wants to move one way and is locked by lack of lead screw.
do I need to undo the motors from the screws and set in a middle position or is there something else wrong that needs resetting. I have looked on the net but the settings are all over the place. at a lost what to do next. michael
-
Ok Terry I think you said in an earlier post that you was going to dump the tb6600. But if you power off the machine you should be able to turn the screws by hand to get it somewhere near the middle.
I think your problem lies with the dir pin might need inverting but you haven't shown how you have wired it or any screen shots of the software about the pins etc...Clive
The more you know, The better you know, How little you know
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
help needed mach 3
By terry1956 in forum CAD & CAM SoftwareReplies: 2Last Post: 16-02-2016, 07:36 PM -
PSU help needed
By John11668 in forum General ElectronicsReplies: 7Last Post: 04-11-2014, 12:21 PM -
PSU wiring help needed
By Boyan Silyavski in forum General ElectronicsReplies: 7Last Post: 25-06-2014, 11:46 AM -
1 3/16"-16 tap and die needed
By dazza in forum Marketplace DiscussionReplies: 4Last Post: 26-12-2013, 05:36 PM -
help needed for .drg files
By swinds in forum Machine DiscussionReplies: 0Last Post: 22-06-2011, 09:18 PM
Bookmarks