Thor, or should that be Zeus?

[Chaz]

My thoughts too, I do spend more time changing tools on my manual mill than cutting, also setting up etc. I just am not sure of the design here, especially with only 4Hp on the spindle, still limited to light cuts at average speeds, there is a reason large mills weighing tons have 20-30-40Hp spindle motors and only move at reasonable speeds.

Understood. Perhaps 'all' Ill get is a very sturdy accurate 'average' machine. I cant fit a 20 HP spindle. The point here was to prove a few points.

1. How much better will something be with higher end kit?
2. The kit I have bought wasnt cheap, but it was not new, so I did not pay full price.
3. I want to see the 'max' of what can be done using single phase power.
4. I like playing around, this is my fun that detracts from a fairly tough day job :-)

Thanks