Post Processor for Heidenhain tnc 145???

[steffeb]

Thanks! I can post it on the cambam forum. :)

You find the file i in the "Tools" meny, and then "view program directory" or something like that. I'm at work now, got no access to cambam. It is on the right of the top menu bar anyway, you'll find it! Then it's located in the "post" directory. Had a hard time to get the TNC 151 post running before i found that directory. :)

[jackpat]

Thanks i have found the post folderrr... next problem when i try to attach it says invalid file??

Cheers,

Jack

[jackpat]

Heidenhain 145.txt

Sorted. This PP is not 100% by any means, but its a good start.

Couple of issues -

After a CC line the Post outputs I value for an incremental move in X and J value for Inc move in Y... i didnt know how to change this so i just open programme in notepad and use "replace all" to change all I's to "IX" and all J's to "IY".

Also anywhere that the programme has a "stop" or "begin programme" or "end programme" the TNC will not read, i simple replaced all of these with a tool call or tool definition (also did this in notepad).

Then your ready to go! i didnt bother much trying to fix the post processor because it didnt take that long to fix in notepad. If anyone can improve the post i'd appreciate it if you put it on here!

[jack]

hi jackpot,
sorry to bother you I couldn't find way to direct message you.

I have seen on one of your earlier posts that you have a HSM post for tnc 151 would you be able to send it to me I have been looking for one but have been struggling

[Clive S]

hi jackpot,
sorry to bother you I couldn't find way to direct message you.

I have seen on one of your earlier posts that you have a HSM post for tnc 151 would you be able to send it to me I have been looking for one but have been struggling

If you read #10 you will find it.