-
12-04-2016 #11
Thanks i have found the post folderrr... next problem when i try to attach it says invalid file??
Cheers,
Jack
-
12-04-2016 #12
Maybe you can change it to ".txt" ? :)
-
12-04-2016 #13
Did you use the .vbs file that was supplied with the 151 conventional post? Upload that too. It`s located directly at c:\
-
12-04-2016 #14
Heidenhain 145.txt
Sorted. This PP is not 100% by any means, but its a good start.
Couple of issues -
After a CC line the Post outputs I value for an incremental move in X and J value for Inc move in Y... i didnt know how to change this so i just open programme in notepad and use "replace all" to change all I's to "IX" and all J's to "IY".
Also anywhere that the programme has a "stop" or "begin programme" or "end programme" the TNC will not read, i simple replaced all of these with a tool call or tool definition (also did this in notepad).
Then your ready to go! i didnt bother much trying to fix the post processor because it didnt take that long to fix in notepad. If anyone can improve the post i'd appreciate it if you put it on here!
-
04-07-2016 #15
hi jackpot,
sorry to bother you I couldn't find way to direct message you.
I have seen on one of your earlier posts that you have a HSM post for tnc 151 would you be able to send it to me I have been looking for one but have been struggling
-
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Bridgeport VMC with Heidenhain control-
By vargai in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 13-01-2015, 02:37 PM -
Help with Post Processor
By superpot in forum CAD & CAM SoftwareReplies: 0Last Post: 20-11-2013, 11:23 AM -
Heidenhain DRO fault
By Lancer in forum General ElectronicsReplies: 5Last Post: 29-06-2012, 09:57 AM -
Vectric Post Processor
By p1lts in forum General DiscussionReplies: 2Last Post: 08-10-2011, 08:02 PM -
Post processor Sei
By 2006Nobull in forum Machine DiscussionReplies: 12Last Post: 04-08-2011, 12:58 PM
Bookmarks