-
08-03-2016 #1
My Z drive not working on cnc plasma it will read movement when movinment on the mach3 dro when using the keyboard or in running a program but won't drive the motor. I have tested the motor seem to work fine any ideas
Sent from my SM-G361F using Tapatalk
-
08-03-2016 #2..Clive
The more you know, The better you know, How little you know
-
08-03-2016 #3
I have the x and y working its just the z works on the dro and dosnt run the motor unsure of what exactly is used internally as I bought the machine
Sent from my SM-G361F using Tapatalk
-
10-03-2016 #4
Any ideas
Sent from my SM-G361F using Tapatalk
-
10-03-2016 #5
-
11-04-2016 #6
Below is the diagnostic screen and main it will move the s axis on the dro the motor is making noise and will work if conected to the x axis wire
Sent from my SM-G361F using Tapatalk
-
09-05-2016 #7
I've checked all the wiring seem to be correct is there somthing in the mach software that could be causing this
Sent from my SM-G361F using Tapatalk
-
09-05-2016 #8
Only thing in software likely to cause problem is Configuration which you can set, if you want to check and find problem swap over X and Z axis motors and move carefully if X stops working and Z works its either the wiring or configuration in Mach3 as motor etc fine then you could swap back and just swap driver over to check Driver ok, I would first of all post your Input settings For XY&Z and current Motor tuning for X and Z axis as it may well be obvious from those what your problem is.
-
09-05-2016 #9
Swaping the driver's or swapind the motor wires from z to x makes no difference I will post a picture on input tomorrow thank you for you help
Sent from my SM-G361F using Tapatalk
-
09-05-2016 #10
So your saying if you swap Z axis motor wires to the Working X axis drive it still doesn't work.? If so then dead motor.
(Daft question here.? . . . Obviously swapping Z motor to X axis will only work if you jog X axis your not swapping then trying to jog Z are you.?)
Have you tried swaping Z axis drive to the X axis motor.? This will eliminate dead Z axis drive. IF Z drive works X motor then sounds like your Z axis motor is dead.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Metal Working Lathe
By DanBlack in forum Lathes, Lathe Rebuilding & ConversionsReplies: 9Last Post: 18-06-2015, 09:47 AM -
x&z not working
By cncjohn in forum Linear & Rotary MotionReplies: 5Last Post: 18-08-2013, 12:58 PM -
EXPERIENCE: Working with JAZZCNC
By m.marino in forum Trading Experience & FeedbackReplies: 0Last Post: 02-10-2012, 11:47 AM -
WANTED: OLD LATHE wanted..WORKING OR NOT
By dannymac in forum Items WantedReplies: 0Last Post: 25-01-2012, 10:06 PM -
Plasma Cutter Drive
By antsals in forum Plasma Table MachinesReplies: 0Last Post: 23-08-2010, 05:28 PM
Bookmarks