Hi Jazz,

Can't combine, one is 5mm and the other is 3mm plus the bed is too small to take both parts ;)

The parts i have been getting working in this thread were never plasma'd - too much detail and the heat would warp them, laser cutting does distort but not as much, costs though - that's why I wanted to bring them in-house.

I could pre-cut the 3mm parts on the plasma, would save metal as i can only order square-cut sheet or blanks and these parts are triangular. Would then need to be a two-step fixing on the mill - fix through the internal aperture wastage and cut the outside then fix clamps and finish the internal details. Would still work though, these are simpler parts to make.

I can plasma 9.5mm if it needs piercing or 19mm if I can edge-start the cut. It's not the favourite flavour of metal for plasma cutting though.