Quote Originally Posted by CharlieRam View Post
Use a M00 at a convenient point, then press cycle start to continue, spindle stop might also be good at this point :)

Yes but the finish cut is one continuous cut, you don't want an M00 in the middle of a continuous cut because you will not get another lead-out and lead-in so a tool mark is going to show, let alone stopping and starting the tool mid-cut will probably break it.

Fitting clamps will mean working in the short space of time while the cutter is up the other end of the job, these parts are small so time is short and this is therefore dangerous. The Z axis mount is wider than the job so all clamps have to be low-profile <=10mm high or it means using a longer stick-out on the tool which again is not good on a 2mm cutter.

These are difficult parts to make well but that does not mean they cannot be made ;)