Thread: Jobs ruined after long run
Hybrid View
-
20-03-2016 #1
quick look at the code shows no issues so not that.
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
-
20-03-2016 #2
Checked every Allen key bolt, every screw and removed covers to check wiring etc, went through every connector to controller and then to PC, everything is tight now, only one screw holding an earth wire was loose enough to take a nip up.
-
21-03-2016 #3
Have you checked for any axes binding. This is mostly likely cause.
After checking this I suggest you try running the same G-code at different feedrates to test if resonance is the cause. If it runs fine at lower feed rates and at higher feedrates then it's most likely Mid band resonance.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help Needed! Small Hobby Jobs!
By spud__666 in forum Metalwork DiscussionReplies: 0Last Post: 03-05-2015, 10:07 PM -
WANTED: 2 nema 23's 76mm long dual shafts 6.35mm plus one 56mm long nema 23 dual shafgt 6.35
By nobby in forum Items WantedReplies: 0Last Post: 24-09-2014, 09:57 AM -
Onsite maching jobs asia
By Mykeltt in forum General DiscussionReplies: 0Last Post: 17-05-2013, 09:14 AM -
RFQ: Looking for Aluminium CNC Milling Service + Lathe Work (2 Separate Jobs)
By biketrialsdave in forum Projects, Jobs & RequestsReplies: 2Last Post: 19-02-2013, 04:06 PM -
is a cnc 3020 right for the jobs i need doing
By RsvRcarl in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 28-03-2012, 01:34 AM
Bookmarks