Quote Originally Posted by Boyan Silyavski View Post
A bit off topic. Now i need your help here.
It's not in the operator's manual, it's in the Parameter List

You need
P0003 set to 2 so that all the parameters you might want to change are accessible to you
P0700 set to 1 for command input to be BOB (panel)
You might need to select the control frequency setpoint source and a few other odds & sods but the Parameter List is where you'll find the settings described -

http://www.acpd.co.uk/sei/s/1488/f123.pdf

Regards,
Nick