Connecting 2.2kw vfd to Mains supply

[JAZZCNC]

Thats interesting. Thanks for sharing. Great info. Does it work with 6mm 2 flute cutter also? Or its to small to see well difference?

Yes works just same with 6mm.
Edit: The Chinese VFD's can be a little slow to re-act but do show difference. Better drives like my ABB monitor it so precise I can tell when it hits hard or soft spots pretty much instantly. It's saved my skin a few times being able to compensate for any changes.

Andrew I haven't personally used the Hitachi but I built a machine for some one who uses the same VFD with same spindle and it's perfectly fine. Infact the whole machine including VFD runs from 13A socket run down to shed via electrical extension cord. This was 5yrs ago and still hasn't burnt the shed down so can safely say it's ok.!!

Also My ABB 2.2Kw VFD is rated 25A and still it's fine run from 13A. I fit lots of these 2.2Kw Spindle VFD setups and I haven't had one that taxs 13A so sleep safe.!