First engraving test :)

[cropwell]

Hi Dave,

Engraving looks good !

I find the problem is usually getting the material flat enough to the X-Y plane to get an even DOC. Taping down to a sacrificial MDF surface which I have skimmed generally works. I use chisel engraving bits with a 0.2 mm flat on the end.

Here's a couple of examples, both are low res photos. The first was done with the chisel point engraver, it is 60x20 on .5mm brass with .1 DoC. The second is done on fibreglass PCB using a 1mm two flute cutter to cut through the copper. It looks good with backlighting but the furnace is never switched off long enough to put that in ! I got the picture by capturing a webcam image, so that too is low res.