. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 27-04-2016 #3
    Fred's Avatar
    Lives in Reigate, Albania.
    Fred
    Last Activity: 24-04-2018 Has been a member for 9-10 years. Has a total post count of 34. Received thanks 4 times, giving thanks to others 1 times.
    If you just want some PCBs for a project then I'd definitely recommend just sending your design off to a board house.
    http://pcbshopper.com/

    If you are looking forward to the challenge of PCB isolation routing then that's a different matter. I found that Eagle and pcb2gcode worked well when I did it. No experience with PCB Wizard in afraid. I ended up finding that UV exposing boards was much better than routing anyway, especially when you get down to SMT stuff and soldermask.
    Last edited by Fred; 27-04-2016 at 09:54 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Mach3 digitizing wizard not saving file
    By dudz in forum Probing, Digitizing & Scaning
    Replies: 0
    Last Post: 08-09-2013, 09:48 PM
  2. Chamfer Feed & Speed - G-Wizard?
    By Tenson in forum Computer Software
    Replies: 4
    Last Post: 05-02-2013, 07:01 PM
  3. G-Wizard?
    By Tenson in forum General Discussion
    Replies: 5
    Last Post: 22-10-2012, 03:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules