VFD ASKPOWER A131 Need Help!

[Clive S]

Toby I think you have to change some parameters read page 17 and look at pn03 and pn04

[toby]

Hi Clive thanks for the reply, Sorry I should of put in my original post the parameters have been set on VFD and I have setup the mach3 following this manual http://www.omc-stepperonline.com/dow...ers_Manual.pdf I appreaciate your response and trying to help.

[JAZZCNC]

This may seem stupid question but it does happen often.?

When you tried the spindle under mach3 control you did enter speed reference didn't you.? Either by entering a speed in the on scrren box or by typing direct speed command in MDI ie: M3 S5000.?

By default mach3 starts with ZERO speed for spindle.