Denford Microrouter V4

[m_c]

Your maths seems good.
What do you mean you only get a reading of 26?
What are you actually commanding?
And do you really mean 550mm?

[andy_con]

Your maths seems good.
What do you mean you only get a reading of 26?
What are you actually commanding?
And do you really mean 550mm?

if I use the arrow keys on the keyboard to jog the x axis for example. I travel the whole length of the machine which is 550mm as stated in the denford manual but the dro readout in mach only say 128

so something isn't right

[m_c]

So it's out by a factor of 4.something.

Are you sure the microstepping is 10?
Easy way to check, is if you mark a motor pulley/screw, then request a move of 3mm, it should rotate one full turn. If it doesn't, then you need to work out why.

[andy_con]

[lucan07]

run the auto configuration on the X,Y & Z axis on the settings tab bottom left above reset

[andy_con]

run the auto configuration on the X,Y & Z axis on the settings tab bottom left above reset

im using machstdmill ive no idea how to get it back to normal mach screen set

[m_c]

I seem to have a recollection of certain drives having the switches the wrong way around, but if that was the case, you'd be out by a far larger factor.
Run the test like I said, and you'll know for sure if it's the microstep setting causing the numbers to be wrong or not.

I think you should be able to swap back to the standard screen by simply selecting the standard screen, however I've never used MSM. Regardless, I prefer to calculate the steps manually, as that way I know if something isn't set how it should be, or I've got a number wrong somewhere.

[lucan07]

If you run machloader create a copy of your setup its a good idea to have a standard screen setup to troubleshoot, and you could run autotune.

Are you sure not mixing Motor tuning and mach default mm's and inches 26x25.4 = 660 would only be 20% out closer than 400%.

[andy_con]

just managed to find and use the autotune which is a great feature.

but still not right, a full x movement of the table now reads 282, so better but not right.

some thing is very odd here

If you run machloader create a copy of your setup its a good idea to have a standard screen setup to troubleshoot, and you could run autotune.

Are you sure not mixing Motor tuning and mach default mm's and inches 26x25.4 = 660 would only be 20% out closer than 400%.