Denford Microrouter V4

[lucan07]

If you run machloader create a copy of your setup its a good idea to have a standard screen setup to troubleshoot, and you could run autotune.

Are you sure not mixing Motor tuning and mach default mm's and inches 26x25.4 = 660 would only be 20% out closer than 400%.

[andy_con]

just managed to find and use the autotune which is a great feature.

but still not right, a full x movement of the table now reads 282, so better but not right.

some thing is very odd here

If you run machloader create a copy of your setup its a good idea to have a standard screen setup to troubleshoot, and you could run autotune.

Are you sure not mixing Motor tuning and mach default mm's and inches 26x25.4 = 660 would only be 20% out closer than 400%.

[lucan07]

You are using a smoothstepper so that I suspect generates pulses rather than PC, I would look closely at the smoothstepper settings if there is a multiplier or something there, some do for servo's to get up to speed. Some good videos on warp9 for setup I saw when considering the smoothstep

[andy_con]

ok set the drivers to 32 steps and half current

used the auto tune feature and doing a full x travel I get 550mm, soft limt isn't working for some reason so I need to look into that

[lucan07]

I got a soft limit bug in latest version went back to previous one ending .20 after hearing a fair few bugs in latest version.

[andy_con]

restarted mach and they are now working.

the machine is working, still need a smooth a few things out but its working

[lucan07]

Its coming together that first cuts always the best