Bridgeport Manual to CNC conversion...

[Davek0974]

Hmm, I followed the same wiring style as the other axes, the drives all enable together from one signal.

Is that the loop between the servo and controller?

Maybe check the connections in the servo cable, that was a pre-made one that came with the motor and controller.

[m_c]

Is the +/-10 connected correctly, and the drive configured to use the correct analogue input?
And is the CSMIO configured to use the correct channel?

[Davek0974]

AFIK yes, i'll double-check the setup tomorrow night.

I'm setting up as the C axis or channel 5 on the CSMIO.

I'll try disconnecting the -10/0/10v lines to see if creeps on its own.

Dave

[Davek0974]

Is the +/-10 connected correctly, and the drive configured to use the correct analogue input?
And is the CSMIO configured to use the correct channel?

Kudos to you - i had the encoder on C axis but analogue on A axis :)

Its running now, needs more tuning as it oscillates when it stops after homing.

Not sure what axis is best, the 2010 screen set seems to be set for XYZA but a good friend advised C axis was more aligned with the Z axis.

At least its alive :)

[Chaz]

Page 39 of the current CS Labs IP-A manual .....