Port setup to trigger rely for plasma torch

[Davek0974]

Sounds like the wrong post-processor there, code error.

[whensparksfly]

Sent from my SM-G361F using Tapatalk

[Davek0974]

Check the box "IMMEDIATE RELAY OFF BEFORE DELAY" its not your issue but should be checked for plasma, might as well set those 1 second times for 0 as well.

The issue you mentioned sounds like the code you are using is not configured for plasma, can you post what software it was from - SheetCam, Aspire etc and maybe post the code as well.

[whensparksfly]

It's the road runner one on mach 3

Sent from my SM-G361F using Tapatalk

[whensparksfly]

What is the error in the photo

Sent from my SM-G361F using Tapatalk

[Davek0974]

Check the box "IMMEDIATE RELAY OFF BEFORE DELAY"

Check the box "DISABLE FLOOD/MIST RELAY"

[whensparksfly]

Ive done all that now still not stopping cuting only at the very end.it that road runner gcode durable for plasma .where could I get a sample gcode from

Sent from my SM-G361F using Tapatalk

[whensparksfly]

Right I got it sorted it was the drawing the whole time. Thanks all for your help have a new problem but will start a new thread

Sent from my SM-G361F using Tapatalk