Thread: Z axis moves below set zero
Threaded View
-
30-05-2016 #27
I doubt its moving that far I think it may be out but he obviously has not RTFM and in other threads has claimed similar which is where we got to auto tuning as simpler than trying to get information required to do calculations for him. Over several different threads its obvious he doesn't quite understand how Mach works when told its definitely tuned right I tried to point out margin of error that would be required so used 2540% to emphasize enormity rather than 25.4x to attain the results claimed.
I would imagine set z Axis zero to top of table rather than top of material as his sole piece of G-code never goes negative or below 1.5mm, just difficult to get information to help would guess all being done from his phone with the minimal responses.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Slaved axis, 2 steppers on Y axis with a PLC4x-G2 ? what about the XP23 connector ?
By pierantoine in forum General ElectronicsReplies: 9Last Post: 23-05-2015, 02:07 PM -
problem: y-axis only moves in one direction using TB6560 board off email
By polysoul in forum Machine DiscussionReplies: 9Last Post: 08-06-2012, 12:12 PM -
NEW MEMBER: Goal - Enable 3-Axis CNC Bed Mill to Perform 5-Axis Milling
By LoveLearn in forum New Member IntroductionsReplies: 2Last Post: 25-01-2012, 08:46 PM -
moves ok when using jog in mach3 but....
By deannos in forum General DiscussionReplies: 2Last Post: 28-12-2011, 09:40 PM -
Precision metal processing (3 axis, 5 axis, 7 axis) OEM
By 7AxisCNC in forum Manufacturer NewsReplies: 0Last Post: 17-05-2011, 02:04 PM
Bookmarks