Threaded View
-
18-07-2009 #1
Good Day All.
After the talks and advice given to me in my [ame="http://www.mycncuk.com/forums/showthread.php?t=975"]Simple Current Limiter (LM317)[/ame] post I have now desided to look into new driver board(s).
I don't have much money left to buy new drivers, only £50-60 so my 1st stop was good old eBay.
I have seen a fair few driver boards on eBay, but most come from China.
Before I start buying new driver boards and possibly wasting my money I would like to ask for your advice again.
I need a driver board to run my 3 Astrosyn MY103H702 stepper motors.
Unipolar: 6.20volts, 1.00amp per phase.
Bipolar Parellel: 4.34volts, 1.4amp per phase.
Bipolar Series: 8.68volts, 0.7amp per phase.
Does anyone know if they are any good and if they last more then 5 min.
So what would you advice?
Thanks for your time.
Best Regards.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
stepmotordriver.com professional stepper motor driver manufacturer from China
By stepmotordriver.com in forum Manufacturer NewsReplies: 0Last Post: 01-03-2014, 09:07 AM -
3 wire stepper motor drivers?
By m_c in forum Stepper & Servo MotorsReplies: 0Last Post: 17-08-2013, 10:01 PM -
Setting up stepper motor drivers
By croy in forum Motor Drivers & ControllersReplies: 25Last Post: 30-09-2012, 09:51 PM -
Purelogic featured stepper motor drivers PLD86 and PLD545.
By Purelogic R&D in forum Manufacturer NewsReplies: 0Last Post: 07-06-2012, 08:36 AM -
Total novice seeks advice on stepper motor drivers
By R.Andersen in forum Motor Drivers & ControllersReplies: 1Last Post: 25-01-2012, 11:34 AM
Bookmarks