CNC Project - Custom Rack Mount Case for Firewall/Router

[Washout]

Hi Nick

Thanks for the likes and yes I did consider doing another vent pattern under the motherboard so the cooler air would get sucked up under that and vented out the top. However, I don't think I'll have to, as according to the management console its running at 26.8 deg C and hasn't budged yet. If it does get near the limit in the future then I'll CNC drill the holes.

I've found on a few other consumer rack chassis that getting shot of the noisy and probably cheap crap 40mm fans and putting a 120 or 140mm fan in does wonders for cooling in switches etc.

[Washout]

Hi all,

A bit of an update - my dual layer setup provoked a bit of comment, but I was asked so did a couple of setup videos:

Networking part:



and the actual setup part:



Back to guitars for the next vid or three.