Denford Triac Spindle control / ATC

[andy_con]

you need to use a spindle v4 board to connect BOB to sprint drive card.

machine cant be used for ridged tapping, threadmilling is your friend

I used a separate encoder for rpm feedback into mach, was about a fiver and works a treat.

I'm running a pmdx126 for my triac, v4 spindle board, pmdx-104 for atc and Ethernet smooth stepper

Evening all,

Really need some advice and help on how and what I need to control the spindle on my new Triac with MACH3. The machine as received is completely stripped of all electronics except for the spindle motor (SEM MT30U4-36) and drive card (Sprint 1200). So far I have managed to wire up the spindle motor and drive board and control it via a 10k pot and verify all works OK (Phew).

The Mill also has an ATC unit that I will add to the conversion later on. What I'm trying to understand is how to control the spindle for the ATC alignment.

My other question is could this setup be used for ridged tapping? I read somewhere that you would need to convert the spindle to an axis via software so the Z and spindle movements can be synchronised.

The spindle motor has a Taco built in, can MACH use this for position or would I need to make a separate encoder disk with a slot and sensor?

Lastly what BOB would people recommend, I would need this to control the spindle and ATC plus limit switches etc or would a PLC be better for the ATC??

Lots of questions I know, if anyone could point me in the right direction I would be most grateful.

Cheers

Mike

[dodgygeeza]

The sprint speed controller is not isolated, is the V4 isolated? if not i think you will find out that this can damage things.

[andy_con]

I'm using v4 board in my triac and microrouter both have sprint drive cards and I don't have any issues

The sprint speed controller is not isolated, is the V4 isolated? if not i think you will find out that this can damage things.

[dodgygeeza]

I'm using v4 board in my triac and microrouter both have sprint drive cards and I don't have any issues

Then the V4 card must be isolating it then.
otherwise you would have 230V ac going onto the input of the V4 card.

[andy_con]

i think the description is pretty clear

http://diycnc.co.uk/cnc-boards-v5-spindle-board/

Fully Opto isolated inputs for live motor controller circuits

[dodgygeeza]

Ok, this is the V5. I used the V4 a long time ago and this did not have isolation built in. But im not sure that they upgraded this though.

[andy_con]

both my denford machines with sprint drive cards use the v4 board