Threaded View
-
26-06-2016 #5
Last Activity: 28-05-2023
I am fairly sure the Kress uses a fairly basic triac switching speed control. One of the functions of the speed controller is to ramp up, rather than an abrupt start. I don't know about the SSR you mention, but the ones I use for furnace control are very much on/off switches, switching at zero crossing.
Basically, I am saying ; exercise caution as it could cost you a Kress 1050.
Cheers,
Rob
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Q: Start Kress 1050 with Gecko540?
By Trulsen in forum Kress Milling MotorsReplies: 8Last Post: 01-10-2013, 04:50 PM -
eBay: Kress 1050 FME-1 Spindle
By viz in forum Items On eBay UKReplies: 0Last Post: 21-08-2013, 04:04 PM -
eBay: Kress 1050 FME router
By rbs in forum Items On eBay UKReplies: 12Last Post: 08-05-2012, 12:40 PM -
Where's the cheapest place to buy a Kress 1050?
By Jonathan in forum Marketplace DiscussionReplies: 30Last Post: 05-01-2011, 07:00 PM -
collets for a Kress 1050
By groov in forum Kress Milling MotorsReplies: 5Last Post: 20-08-2009, 11:54 PM
Bookmarks