Thread: A4 Reference Chart Storage
Hybrid View
-
29-06-2016 #1
Where from Nick ? I can find an all black one on AliExpress for $40, which is £30 since this country has sipped from the poison chalice.
-
29-06-2016 #2
good to know Nick
I'm starting to compile A4 sheets for drill speeds tap sizes etc and was thinking about removing the front cover from a ring binder and screwing the back cover to the wall. This would leave the metal spring rings available to hold doc wallets or punched laminated sheets.
Bit cheaper but not so slick and may not last so longLast edited by routercnc; 29-06-2016 at 05:17 PM.
-
29-06-2016 #3
I can't find the link again for the one in the photo but it was £25 in the UK.
Being able to lift out or replace a single page holder with greasy hands without fumbling and fiddling is fantastic.
Mine were free from the skip, when Kraft closed the Sheffield based Cadbury Customer Contact Centre, I'd never seen them until I joined Cadbury IT Support.
- NickYou think that's too expensive? You're not a Model Engineer are you? :D
-
29-06-2016 #4
-
29-06-2016 #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Establisihing reference for rail alignment
By tropostudio in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 14-05-2015, 08:28 PM -
Heidenhain ME 101 Tape reader or alternative program storage.
By corkcnc in forum Machine Control SoftwareReplies: 3Last Post: 19-03-2014, 11:28 AM -
Revised G-Code Quick-Reference / Cheat Sheet
By DanielF in forum Machine Control SoftwareReplies: 2Last Post: 20-02-2014, 11:14 AM -
Chip load chart
By motoxy in forum Machine DiscussionReplies: 1Last Post: 17-09-2012, 10:05 PM -
Schematic Symbol Reference
By Lee Roberts in forum General ElectronicsReplies: 1Last Post: 23-01-2008, 03:23 PM
Bookmarks