Help required with mill conversion / upgrade.

[swarf-boy]

Hi Chaz,

Yes that's what I was able to attach.


I have also just attached an xcel spreadsheet I did, showing everthing I have worked out so far.
( probably a bit unconventional, but it seamed a simple way to plan it)

Feel free to mark my homework...... LOL.

Comments welcome from all.

[Chaz]

Hi Chaz,

Yes that's what I was able to attach.


I have also just attached an xcel spreadsheet I did, showing everthing I have worked out so far.
( probably a bit unconventional, but it seamed a simple way to plan it)

Feel free to mark my homework...... LOL.

Comments welcome from all.

I dont see the spreadsheet. Can you put it on googledocs or dropbox or similar? Else I can pm you my address.

I did the same (excel) for one machine I retrofitted (IP-A with Mitsubushi servos).

[swarf-boy]

.

[swarf-boy]

Pm sent mate

[battwell]

wont your new drives run position mode? step/direction?
would make it much easier to set up and would have saved getting the csmio.

i can help you with the ecogoo .

[Chaz]

Hi Chaz,

Yes that's what I was able to attach.


I have also just attached an xcel spreadsheet I did, showing everthing I have worked out so far.
( probably a bit unconventional, but it seamed a simple way to plan it)

Feel free to mark my homework...... LOL.

Comments welcome from all.

Ah, didnt see you updated the original post. Ill take a quick look. Actually, send me your email address and Ill dig out what I did.